Support Forums/Technical Support Forums/Mercury/Force Outboards

Answered

Temp gage not working

Dockmasterfhyc
asked this on August 02, 2010 09:22

The water stream is fine so I know water is cooling motor.What wires do check? I see tan at the gage. Plus it might bethermastat

Can"t find it. Is it near top of motor. Want to pull it and replace it.
 

Comments

User photo
steve maciosek

Check the temp sending uint first they are known to go bad good luck steve.

August 02, 2010 10:33
User photo
Dockmasterfhyc

Were will I find the temp unit?

August 02, 2010 14:10
User photo
Eric
Boat Parts Support Forum - Crowley Marine

Hey Dockmaster,

The temp unit should be located somewhere on your cylinder head. It might be helpful to look up your motor diagram and check the cylinder head. Hope that helps!

--Eric

September 03, 2010 14:16
User photo
carl orlandi

my merc 225 opti gives me high temp warning howerver my temp never reqally exceeds 132 degrees all sorts of warning wistle some times... usually happens when in idle once get going warning disapears.u

September 06, 2010 06:19
Add a comment