Support Forums/Technical Support Forums/Mercury/Force Outboards

Answered

impeller replacement on a 25 hp outboard mercury

Dplcterry
asked this on February 19, 2010 15:30

How do you disconnect shift shaft from lower unit when unbolting lower unit to replace impeller? I remove the 4 bolts holding lower unit to shaft housing, but can not figure out how to disconnect shift shaft.

------------------
Submitted from: http://www.crowleymarine.com/mercury_parts/676/14.cfm
 

Comments

User photo
Scott
Boat Parts Support Forum - Crowley Marine
Ajax_loader_small Answer

If you can't see how the shift shaft is connected to the lower unit then you may need to remove the top cover and see if you can disconnect it from the top end connected to the powerhead. Hope that helps.

February 19, 2010 15:30
User photo
Chunks1140

You have to take the starter lose and you will see a pin under it remove only the pin and that is where linkage is connected.

October 19, 2011 14:35
Add a comment